Step 2: Your computer will need to be in the same IP address range of the DWL- AP for configuration. The default IP address of the. The DWLAP allows you to select whether or not either wireless band can pass information, via the Internal Station Connection option. If this feature is not. DWLAP. b/g Access Point. Command Line Interface Reference Manual. First Edition (January ). RECYCLABLE.

Author: Mezile Shazragore
Country: Anguilla
Language: English (Spanish)
Genre: Video
Published (Last): 23 November 2004
Pages: 18
PDF File Size: 16.76 Mb
ePub File Size: 4.29 Mb
ISBN: 267-1-56307-443-3
Downloads: 21359
Price: Free* [*Free Regsitration Required]
Uploader: Didal

Next, you will need to run the Network Setup Disk on all the other computers on your network.

D-Link Technical Support

Front Panel A blinking light indicates data is being transmitted via the Ethernet port. Step 5 There are 2 different filters you can use to control traffic on your network. Step 2 Enter your username admin and your password leave blank by default. Allows you to connect two wireless LANs together.

Page 70 Troubleshooting continued 4. Insert one end of the cable to the Ethernet port on the back panel dwl-21000ap the DWLAP and the other end of the cable to your network switch or router.


D-Link AirPlus Xtreme G DWL-2100AP User Manual

Devices with a ddl-2100ap next to them are still available on the network. Accept — Blocks all clients except for what you enter in the list. Rear Panel Power Receptor Used to connect the supplied power adapter.

Then press the Enter or Return key.

D-link DWL-2100AP Install Manual

Enter text from picture: Step 5 Click Manua, and then click Continue to save your settings. Allows you to enable or disable the broadcasting of the SSID to network clients. Don’t show me this message again. D-Link products let you access your network from virtually anywhere you want.

To print the manual completely, please, download it. You make this up yourself. To check on the IP address of the adapter, please do the following Position your devices so that the number of walls or ceilings is swl-2100ap. This feature effectively segregates the wireless band of your choice from the rest of the Network.

Select Enabled from the corresponding drop down box to enable the feature.

Step 8 Enter your encryption key. Enter text from picture: After you have tried other methods for troubleshooting your network, you may choose to Reset the DWLAP to the factory default settings.


You must place a checkmark in the Device Name box to change the name.

DWLAP | Dlink products Configuration And Installation On D-Link Blog Home

Products shall be fully insured by the customer. Use this function to assign the same IP address to a device at every restart. Home screen will appear.


This is considered your internal network. Power A solid light indicates the unit is properly powered.

Access Point- is the default setting. Enter your new user name and then enter the old password if any. Page 9 OFDM works by splitting the radio signal into multiple smaller sub-signals that are then transmitted simultaneously at different frequencies to the receiver.

A blinking light indicates data is being transmitted via the Ethernet port. Please read the following if you are having problems. Click the Support tab. The repaired or replaced packages will be shipped to the customer via UPS Ground or any common carrier selected by D-Link, manul shipping charges prepaid.