Product category: PLCs – Omron – C – Omron CH-LK (CHLK) This unit is fully tested prior to. Q: Can CH-LKV1 Host Link Unit be used with CS1-series Programmable Controllers?. CH Units that use the CPU bus, SYSMAC LINK Unit, CHW-SLK23/24 ( wired) CHW-SLK13/14 (optical). Controller Link Unit, CHW-CLK21 (wired ).

Author: Volkree Tesida
Country: Barbados
Language: English (Spanish)
Genre: Music
Published (Last): 12 May 2012
Pages: 499
PDF File Size: 13.21 Mb
ePub File Size: 20.22 Mb
ISBN: 576-5-21029-587-6
Downloads: 95804
Price: Free* [*Free Regsitration Required]
Uploader: Kazilkree

Maybe the PLC power supply is bad. This means you cannot use the small peripheral port for anything other than a hand held programmer.

Can I move the host link to other slot of BB? You’ll need to tell us in more detail what c2000h have done. I will check the cable one more time! I would still think you should see the RCV light. Could anyone help me how to check and slove this problem? The DIP switch front are 0;0;5;2 back are off;off;on;off;0v Please help me! It determines if addressing is required in the event of a muli-link system. I just didn’t relate the issue when reading the manual.

  BENZINSKI MOTORI PDF

The restriction is strictly mechanical.

But there’s still no RCV light Please help me! Posted 14 Nov edited. One of the other old school guys will have to answer this one.

Posted 22 Nov Edited 15 Nov by sokhanh. With the information you have provided, there is no way for us to tell.

Posted 13 Nov What is the part number of your back plane? Posted 20 Nov Started by sokhanh13 Nov If your application is not sending an address and a calculated FCS then it will not communicate with pin 3 set to ON. The 25 pin connector would run into the bottom of those peripheral units if you used these slots.

Omron C500CN221EU Programming Cable, For Use With C200H-LK201 PLC, 6 ft

If it is not blinking then you have a bad connection. The long port at the bottom is for a 3G2A6-LK Thank you for your reoly! Prev 1 2 Next Page 1 of 2. The dip witches in the host link are li201 but still not connect. Posted 15 Nov edited. The PLC configuration does not matter.

On the older ones, it was only intended for the hand held programmer. Posted 14 Nov It is a pre-Alpha series.

  ANGEWANDTE TENSORRECHNUNG PDF

Help me with c200h-lk201

Sign In Sign Up. After revisiting this I found conflicting information in the manuals. The manual in the link I posted above describes these functions. C Series Host Link Units. Be careful what you plug into it.

By the way, can you tell me the different between lkV1 and lj201 I did notice that both of his modules are in the restricted slots.

Omron CH-LK (CHLK) – Axdos AB | PLCSWEDEN | Automation Spare Parts

You need to be a member in order to leave a comment. Pin 3 on the back may be the problem depending on how your custom application was programmed. For communications with CX Programmer, you should be able to use the same cable that is currently connected to you custom application. I also tried with this cable LK Coputer On the CPU, led “run” is green.

This is basically the c200y as the rack mounted unit you have. You should verify the cable.